MOXIE 1800 SUPER-ADMIX is a ready to use liquid admixture formulated to stop moisture vapor migration and alkali efflorescence attack above and below grade. Ideal for use on stucco, shotcrete, mortar and white portland cement pool plaster applications.
A complex process converts the by-products of hydration into a higher density of cementitious materials thereby reducing permeability. The additional cementitious materials, by their very chemical and physical nature, produce concrete with a much greater density and surface hardness, a dramatic increase in bond, flexural, tensile and compressive strength, while achieving near-zero capillary voids.
Adhesion characteristics of the surface are improved by providing the ideal surface dry condition necessary for coatings, paint or floor coverings. The use of MOXIE 1800 SUPER-ADMIX alone, without any other additives, will produce the highest quality concrete possible for the given mix design.

Advantages:

MOXIE 1800 SUPER-ADMIX is an in-organic, chemically reactive, complex catalyzed silicate that initially forms an integral colloidal gel membrane prior to initial set. This eliminates bleed water and restricts the rapid evaporation of surface water, even in gusty wind conditions, which prevents shrinkage cracking AND SLAB CURL, and provides an integral curing compound . Additionally the colloidal gel mass serves as a thermal barrier that conserves heat generated by hydration during colder conditions, reduces heat absorption in hot weather, and forms a passive, corrosion inhibiting, barrier around reinforcing steel, ultimately forming a permanent, cementitious barrier. This process continues to parallel the curing process by forming additional cementitious material for 28 days. From 28 days to completion of hydrating free mix water the final phase completes the last of the chemical process converting and reducing the remaining capillary voids present after hydration to near-zero.

ASTM C157, C494, C156, C567, C666, C805, D4263, D5084, E96
C309 Performance criteria,   CARB   EPA    USDA     VOC=0

If ambient temperature is below 50o F MOXIE Fastset50 Fastset50 may be used to decrease set time up to 50%, or above 85o F, a retarder may be used per manufacturer’s instructions to extend the working time of the concrete. If a retarder is used, mixing should continue for at least 15 minutes before placing, ASTM C94 - Specifications for Ready Mix. Omit sand/visqueen vapor barrier, do not use curing compounds, FOG mist only with water if necessary